Bluetooth 2.0 Shield (Slave) for Arduino

$13.16

  • Model: AS0000811B
  • Shipping Weight: 0.25gram
  • 495 Units in Stock

Add to Cart:



The Bluetooth Shield integrates a Serial Bluetooth module. It can be easily used with MCU for transparent wireless serial communication.  The Bluetooth Shield could be setting to Master or Slave by user.
Serial port Bluetooth module is fully qualified Bluetooth V2.0+EDR(Enhanced Data Rate) 3Mbps Modulation with complete 2.4GHz radio transceiver and baseband. It uses CSR Bluecore 04-External single chip Bluetooth system with CMOS technology and with AFH(Adaptive Frequency Hopping Feature).

Features

  • Standard Shield designed that you can use it easily.
  • Up to10m communication distance in house without obstacle
  • UART interface (TTL) with programmable baud rate (SPP firmware installed).
  • Default baud rate: 38400, data bits: 8, stop bit: 1, Parity: No parity.
  • Default PINCODE:”0000”.
  • A full set of configuration commands.
  • On board PCB antenna.
  • With demo code for Arduino

Notice

Only between master device and slave device can be paired with each other. Between Master and Master devices or Slave and Slave devices can't be paired each other. The Slave mode could be paired with PDA, PC etc.

Shipping list

  • 1 x Bluetooth Shield

 

IMG_9812IMG_9815IMG_9837IMG_9852

This product was added to our catalog on Sunday 13 July, 2014.

Your IP Address is: 174.129.148.239
Copyright © 2017 Maker Studio